items at £0.00

Plug in 7 Day Multiple Heater Control via Mains Cable

Plug in 7 Day Multiple Heater Control via Mains Cable

(1 results)

The RX9913 is a plug in cassette or Module that simply clips in to the top of the panel heater. It is a programmable module that provides common 7 Day digital time control of up to 20 panel heaters by means of a Pilot Wire or Mains Borne Signalling.


Compatible with the Dimplex Monterey , Girona , Saletto and EPX Ranges.


Ideally suited to a commercial environment providing 7 day control over one zone or room, perhaps ideally suited to a corridor or office environment. An open large environemt that requires a number of panel heaters that are switched simultaneousely, the programmer then has the ability to switch the heaters off on a Saturday and Sunday.


Note: For Mains Borne Signalling Control each heater must be fitted with an RX9913.

Mains borne signalling (MBS) uses the standard twin and earth wiring in the domestic supply circuit to carry a modulated signal between each heater. A receiver cassette is required in each slave heater to decode the signal. Unique electronic identity codes in each programmer prevent interference with receivers in different zones/buildings and negate the need for additional mains filtering.



  • The Master Panel Heater fitted with the RX9913 can control upto 20 slave Heaters
  • Mains Borne Signalling Control requires RX9913 Modules to be fitted to every slve heater
  • Up to 7 Customised Programmes for every day of the week switching the heaters between Comfort and Setback Modes
  • Manual Override Feature for Cold Periods
  • The Module is removable to Provide easy programming
  • Backup battery saves your programming for 4 Hours in case of power failure
  • Easy User friendly programming guide displayed on the rear of the removable Module
  • Grid // List 

    Grid // List